FC: Omnibus Fireworks V2 _Integrated R-XSR _EU. Firmware

FC: Omnibus Fireworks V2 _Integrated R-XSR _EU. Firmware

Quantity
03020006
  • The FrSky RXSR-FC (OMNIBUS F4 Fireworks) uses the ICM20608 over SPI to produce stable flight performance. Integrated with the RXSR receiver mounted on-board protection box, and the ICM20608 runs perfectly under 32k Gyro loop. Also onboard are a barometer and AB7456 OSD chip for the Betaflight integrated OSD.

    The RXSR-FC (OMNIBUS F4 Fireworks) supports 3-6s Lipo direct input, built-in hall Current Sensor and Power Filter as well. The on Board PDB is tweaked by using 12-Layer PCB design. There is only 0.2-0.5 mohm internal resistance from input to each output pad.

  • STM32 F405 MCU, Runs Betaflight firmware (supported from v3.2)
  • FrSky RXSR receiver in protection box
  • ICM20608 over SPI Bus in dampening box (optional MPU6000)
  • 30.5×30.5 mm mounting holes
  • Supports Lipo direct plug-in (3-6S)
  • Built-in sensor damper
  • Supports 5V 1A BEC output (Buck)
  • Supports 8V 1A BEC with LC filter output for the camera and VTX (Buck)
  • STM32 controls OSD chip over SPI in DMA mode (Betaflight OSD)
  • Built-in hall Current Sensor
  • Built-in Professional Level PDB
  • More caps to reduce power noise.
  • Tantalum Capacitors can be added to the board (not included)
  • Solder pads added for VTXand Camera Control (next to Video pads)
  • The orientation of IMU FPC optimized
  • Gyro ribbon cable redesigned to fit without extending outside the board
  • Added an 8v BEC and LC Filter for the camera and VTX power
  • This board now has 5 UART ports
Q:How to setup the F.Port for RXSR-FC (OMNIBUS F4 Fireworks V2)?
A:Choose and flash the FW in Betaflight: OMNIBUSF4FW
Paste command to CLI:
resource SERIAL_TX 11 C08
resource SERIAL_RX 11 C09
feature SOFTSERIAL
feature TELEMETRY
serial 0 0 115200 57600 0 115200
serial 30 64 115200 57600 0 115200
set serialrx_provider = FPORT
set serialrx_inverted = OFF
set serialrx_halfduplex = ON
save

Submit your review